Xerox 7800/DX

Hướng dẫn sử dụng máy in laser màu Xerox 7800/DX Phase

Model: 7800/DX | Brand: Xerox

Sản phẩm trênview

The Xerox 7800/DX Phase Color Laser Printer is designed for professional environments requiring high-quality color printing and robust performance. This printer offers advanced capabilities for graphic-intensive tasks, including industry-leading media flexibility and professional color management technologies.

Xerox 7800/DX Phase Color Laser Printer with multiple paper trays

Hình 1: Mặt trước view of the Xerox 7800/DX Phase Color Laser Printer, showcasing its multi-tray design and control panel.

Hướng dẫn thiết lập

1. Tháo dỡ và sắp xếp

  • Carefully remove the printer from its packaging. Due to its weight (approximately 256 pounds), it is recommended to use appropriate lifting equipment or assistance.
  • Place the printer on a stable, level surface capable of supporting its weight and dimensions (27.52 x 25.24 x 37.52 inches). Ensure adequate ventilation around the unit.

2. Kết nối nguồn điện

  • Kết nối dây nguồn với máy in và sau đó kết nối với ổ cắm điện có nối đất.
  • Nhấn nút nguồn để bật máy in.

3. Lắp đặt hộp mực

The Xerox 7800/DX uses separate toner cartridges for Black, Cyan, Magenta, and Yellow. Refer to the printer's internal diagrams for specific slot locations.

  1. Mở nắp truy cập phía trước của máy in.
  2. Unpack each toner cartridge (compatible cartridges include 05R02801, 05R02802, 05R02803, 05R02804, 05R02805, 05R02806).
  3. Lắc nhẹ hộp mực để mực được phân phối đều.
  4. Lắp từng hộp mực vào khe cắm tương ứng với màu sắc được mã hóa cho đến khi nghe thấy tiếng tách.
  5. Đóng nắp che phía trước.
Close-up of a printer's internal components, possibly showing toner cartridge slots

Hình 2: Ví dụample of an internal printer view, indicating where toner cartridges are typically installed.

4. Nạp giấy

The printer features multiple paper trays with a maximum input sheet capacity of 3140 sheets.

  1. Pull out the desired paper tray. The printer has 2 trays as standard.
  2. Adjust the paper guides to fit the paper size. The printer supports various sizes, including 8.5 x 11 inch and up to 11 inches in width.
  3. Load the paper (plain paper is supported) into the tray, ensuring it is flat and below the maximum fill line.
  4. Gently push the tray back into the printer.
  5. Confirm the paper type and size on the control panel if prompted.

5. Cài đặt phần mềm và trình điều khiển

To enable printing from your computer, install the necessary drivers.

  • The Xerox 7800/DX is compatible with PC, Mac, and Unix operating systems.
  • Hãy truy cập trang hỗ trợ chính thức của Xerox. webTrang web này cung cấp các trình điều khiển mới nhất cho hệ điều hành của bạn.
  • Làm theo hướng dẫn trên màn hình để hoàn tất cài đặt.
  • Connect the printer to your computer via USB or Ethernet cable.

Hướng dẫn sử dụng

1. Bảng điều khiển kết thúcview

The printer features a touchscreen control panel for easy navigation and settings adjustment. Use the touch interface to access menus, check printer status, and configure print jobs.

Close-up of a printer's touchscreen control panel

Hình 3: Chi tiết view of the printer's touchscreen control panel, showing various menu options.

2. In ấn cơ bản

  1. Mở tài liệu bạn muốn in trên máy tính.
  2. Chọn "In" từ menu của ứng dụng.
  3. Choose the Xerox 7800/DX printer from the list of available printers.
  4. Adjust print settings as needed, such as:
    • Color/Monochrome: The printer supports full color output with a maximum resolution of 1200 x 2400 dpi.
    • In hai mặt: Automatic dual-sided printing is supported.
    • Nguồn bài viết: Select the desired paper tray.
    • Bản sao: Up to 312 copies per run.
  5. Click "Print." The printer has a maximum print speed of 45 pages per minute (ppm) for both color and monochrome. Initial page print time is 1-2 seconds.

3. Kết nối

  • Mạng Ethernet: Connect the printer to your network using an Ethernet cable for shared access.
  • USB: A single USB 2.0 port is available for direct connection to a computer.

BẢO TRÌ

1. Thay thế mực in

When a toner cartridge is low or empty, the printer's control panel will display a notification. Replace cartridges as follows:

  1. Open the front access panel.
  2. Cẩn thận tháo hộp mực rỗng bằng cách kéo thẳng ra.
  3. Unpack a new, genuine Xerox toner cartridge of the correct color.
  4. Shake the new cartridge gently.
  5. Insert the new cartridge into the corresponding slot until it locks into place.
  6. Đóng nắp che phía trước.

2. Vệ sinh

  • Bên ngoài: Lau các bề mặt bên ngoài bằng giẻ mềm, dampSử dụng khăn không xơ vải. Tránh sử dụng chất tẩy rửa có tính mài mòn.
  • Nội thất: Periodically clean the interior of the printer, especially around the paper path and toner area, using a dry, lint-free cloth or a specialized printer vacuum. Refer to the printer's on-screen instructions for specific cleaning procedures.

Xử lý sự cố

This section addresses common issues you might encounter. For more detailed troubleshooting, consult the full service manual or contact Xerox support.

Các vấn đề thường gặp và giải pháp:

  • Máy in không phản hồi:
    • Kiểm tra các kết nối nguồn điện và đảm bảo máy in đã được bật.
    • Kiểm tra kết nối mạng hoặc cáp USB.
    • Khởi động lại cả máy in và máy tính của bạn.
    • Ensure the correct printer driver is installed and selected.
  • Chất lượng in kém:
    • Kiểm tra lượng mực in và thay thế những hộp mực sắp hết.
    • Perform a print head cleaning or calibration from the control panel.
    • Hãy đảm bảo bạn đang sử dụng loại giấy phù hợp với cài đặt in của mình.
  • Kẹt giấy:
    • Follow the on-screen instructions on the control panel to locate and clear the jam.
    • Hãy đảm bảo giấy được nạp đúng cách và không bị quá đầy khay.
    • Loại bỏ mọi vật lạ khỏi đường dẫn giấy.

Thông số kỹ thuật

Tính năngĐặc điểm kỹ thuật
Tên mẫuXerox 7800/DX
Công nghệ in ấnTia laze
Đầu ra máy inMàu sắc
Tốc độ in tối đa (Màu/Đen trắng)45 trang/phút
Max Print Resolution (Color/Monochrome)1200 x 2400dpi
In hai mặtTự động
Công suất tờ đầu vào tối đa3140 tờ
Số lượng khay2
Kích thước phương tiện tối đa8.5 x 11 inch (up to 11 inches width)
Thiết bị tương thíchPC, Mac, Unix
Công nghệ kết nốiEthernet, USB
Giao diện phần cứngUSB
Phương pháp kiểm soátMàn hình cảm ứng
Dung lượng lưu trữ bộ nhớ2048MB
Kích thước sản phẩm (D x R x C)27.52 x 25.24 x 37.52 inch
Trọng lượng sản phẩm256 pound
Các thành phần bao gồmMáy in Laser
Compatible Cartridge Numbers05R02801, 05R02802, 05R02803, 05R02804, 05R02805, 05R02806

Thông tin bảo hành

The Xerox 7800/DX Phase Color Laser Printer comes with a full manufacturer's warranty. For specific terms and conditions, please refer to the documentation included with your product or visit the official Xerox webđịa điểm.

Lưu ý quan trọng: All returns must be authorized by Xerox Corp. No exceptions.

Hỗ trợ khách hàng

For further assistance, technical support, or to access additional resources, please contact Xerox Customer Support or visit their official webđịa điểm.

Bạn có thể tìm thêm thông tin và tài nguyên hỗ trợ trên Xerox Store on Amazon or the main Xerox corporate webđịa điểm.

© 2023 Tập đoàn Xerox. Đã đăng ký Bản quyền.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.